Tabla de contenido
Idiomas disponibles
Idiomas disponibles
BASE PLATE INSTALLATION
Respecting the overall size, fix to ground the base plate (Fig. 5) through 4 sturdy
screw-anchors or drown it into the concrete.
Plan for one or more sheathing for the passage of the power lines.
Note: It is necessary to know the rack dimensions to can calculate exactly the
counter-plate positioning.
MOTOR AND RACK FITTING
The rack shall be fitted over the motor support, at a certain distance from It.
Its height can be adjusted thanks to the holes In the rack.
The height adjusting is necessary to prevent the gate leaning on the driving gear
(Fig. 6, 7).
To fix the rack on the gate, drill some Ø 5 mm holes and thread them using a
M6 screw tap.
The driving gear needs a clearance of about 0,5 / 1 mm from the rack.
To fix the gearmotor to the base plate, insert and tighten the two socket head
screws into the specific housing (Fig. 8).
Note: It is important to lock the two socket head screws forcefully, making sure,
that the gearmotor is steady on the ground, during the whole gate running.
LIMIT SWITCH FITTING
In order to determine the gate travel length, place two cams at the ends
of the rack (Fig. 9).
Move the cams on the rack teeth to adjust their opening and closing travel.
To fix the cams to the rack, tighten the screws issued.
Note: In addition to the electric stop cams mentioned above, you must also install
strong mechanical stops preventing the gate from sliding out from the top guides.
ELECTRICAL CONNECTIONS
To correctly connect the gearmotor to the control unit, follow the table below:
COLOUR
Black
Brown
Grey or light blue
Yellow / green
GROUND CONNECTION
The system must be grounded.
Use the predisposed clamp, connected to the yellow / green cable, to connect the
gearmotor to the ground system.
MAINTENANCE
To be carried out exclusively by skilled persons after the power supply to
the motor has been interrupted.
Periodically, when the gate is standstill, clean and keep the guide free from stones
and dirt.
10/20
175
320
DESCRIPTION
Phase 1
Phase 2
Common
Ground
ITA
ENG
FRA
150
30
FIG. 6
Measurements in mm
ESP
DEU
6-1624804
FIG. 5
FIG. 7
FIG. 8
FIG. 9
rev.2
06/10/2016
Tabla de contenido
