O Perating Conditions; Afety Instructions To Be Observed On Commissioning; Achine - SUHNER MACHINING BEM 6 Documentación Técnica

Air connection inner diameter
Air consumption per cm stroke
Tool hoder: Collet chuck
Sleeve mount DIN 55058
Running trueness
Maximum speed
Working speed
-1
50Hz 2900min 0.37kW
-1
50Hz 1450min 0.37kW
-1
60Hz 3500min 0.44kW
-1
60Hz 1750min 0.44kW
Type of motor protection
Motor output rating
Motor speed rating 50Hz
System voltage
Weithg
Paint coating
2.5 O
perAting cOnditiOns
Temperature range during operation: +20 to +50°C
Maximum relative air humidity: 90% at +30°C, 65% at
+50°C
Compressed air: 5-7bar
Compressed air for pneumatic according to DIN ISO
8573-1 [5/4/4]
Handle tools with caution; keep tools in clean and
sharp condition and observe the tool manufac-
turer's instructions with regard to the use of cool-
ants and tool holding devices.
Use rotational and advance speeds which are assigned
to the tool and to the material.
2.6 s
AFety instructiOns tO Be OBserVed On
cOmmissiOning
Before all work on the machine, it must
first be disconnected from the power sup-
ply.
Only a qualified person familiar with the safety regulations
may start up the machine.
Always conduct test runs without workpieces.
Check the sense of rotation before starting the machine.
The operator must make sure that the components are
integrated and operate safely in the machine.
Only a qualified person may connect the electrical power
supplies in accordance with the local regulations.
The local grounding regulations must be observed and
implemented, and this implementation inspected.
Do not start the machine until the spindle has come to a
stop.
Use only suitable tools, and never modify tools for an ap-
plication they have not been designed for.
After transport, all electrical and mechanical connections
must be examined for damage and loosening, and any
remedial measures taken.
The machine's working area must be unobstructed and
4mm secured against unauthorized access.
0.08 l When internal cooling is used, please observe the instal-
ER16 lation instructions issued by the manufacturers of the at-
ST16 tachment and rotating union.
0.02mm The motor's and spindle's sense of rotation may be
10000min-
1
checked only when there is no tension in the belt. Cor-
recting a wrong sense of rotation involves swapping over
-1
1090-7730min any two of the phase conductors.
-1
550-3870min The motor cable's shielding must be connected to the
-1
1300-9280min motor housing over a large area at the terminal board.
-1
660-4650min
IP 55
0.37kW/0.44kW
-1 -1
2'900min /1450min
230/400/460V, 50Hz
3.1 m
16kg
RAL5012
3.1.1 c
Loosen the screws and remove the cover.
Loosen screws (1). Lower motor with adjusting screw (2).
3. h
anDling

Achine

hAnging tOOthed pulleys
Bring machine to complete standstill.
/o
PEration
29