How To Disassemble And Clean - Royal Prestige maXtractor ULD-322NB Manual De Usuario

HOW TO DISASSEMBLE AND CLEAN

1 1
Switch OFF and unplug the power cord
from the wall outlet.
Note |
• Extract all the remaining pulp in the
juicing b owl b efore s topping the
maXtractor™.
• F o r e a s i e r c l e a n u p , o p e r a t e t h e
maXtractor™ for an additional 30 seconds
after the juice is extracted.
• When the hopper is stuck, press the
REVERSE – OFF – FORWARD button in
this order, switching back and forth 2 to
3 times to dislodge. Then place hands on
the lower part of the hopper and fi rmly
press down simultaneously turning the
hopper counter clockwise to open.
Turn the hopper counter clockwise to
2
open.
Note |
• When moving the appliance, do not
lift by grabbing the hopper. Always lift
the appliance by grabbing the base or
handle.
3 Turn the top-set counter clockwise and
lift off the base.
18
4
Remove the UltraSqueezer™, strainer and
rotation wiper unit from the juicing bowl.
Clean with provided brush.
Note |
• Immediately clean the maXtractor™
after each use. If remaining residue in
the maXtractor™ dries up, it can make
disassembling and clean-up difficult.
The excess buildup can cause poor
performance in future uses.
• For easier disassembly, place the top-set
in the sink and run water through the top-
set.
• Thoroughly dr y the bot tom of the
UltraSqueezer™ where it connects to the
metal cylinder shaft on the base.
Place the juicing bowl under running
5
water and unplug the compression
silicone to clean the pulp spout.
• Soak the juicing bowl in a solution of
Tip |
warm water with baking soda or little bit
of bleach to clean the excess buildup.
* The products illustrated/photographed in this booklet may vary slightly from the actual product.
6
Under running water, clean the outside of
the UltraSqueezer™ with a dish scrub. Use
the tip of the cleaning brush to push out
any residue in the crevices on the bottom
of the part.
Tip |
• Thoroughly clean the UltraSqueezer™
ensuring that it is clean without any residue.
• Completely dry before using.
Note |
• After juicing ingredients with seeds, make
sure to thoroughly clean the bottom
crevice of the UltraSqueezer™. If this area
isn't properly cleaned, it can aff ect the
balance between the UltraSqueezer™ and
the strainer and damage the parts.
Clean the base with a soft damp towel
7
and dry.
Note | • If the towel is dripping wet, make sure
to squeeze out the excess liquid before
using it on the maXtractor™.
Quick Rinsing
With the smart cap closed, fi ll the
1
juicing bowl with water and turn on
the maXtractor™.
2 Let it run for a moment. Open the
smart cap and let the water run out
of the juicing bowl.
Tip |
• It is not necessary to completely
clean the maXtractor™ when making
multiple juices during a single juicing
session.
• When fi nished juicing, always
disassemble and clean thoroughly to
prevent residue buildup.
19