Tabla de contenido
1
LOWER THE LIGHTS WHEN LOADING ACCESSORIES.
•
Remove the rearmost knob on
each side of the lights.
•
Swing the lights down and out
of the way.
•
Load and secure your
accessory according to its
instructions.
•
Swing the lights back into
place and replace the knobs.
•
Fully tighten knobs to 1.5 Nm.
NOTE: You may also lift
your accessory over the fully
installed lights or slide your
accessory in from the side.
•
Unplug the vehicle wiring harness from your vehicle and the back of the EXO SwingBase™.
•
Unplug the main wiring harness from the front of your EXO SwingBase.
•
Remove the cable clips from the bottom of the EXO SwingBase arms.
•
Remove the knobs and carefully detach the light assemblies one at a time.
•
Store the lights in a safe place.
• Attachment hardware can loosen over time. Check and tighten if necessary, before each use.
• Be sure all hardware is secured according to instructions. Failure to perform safety checks before
driving away can result in property damage, personal injury, or death.
CARE AND MAINTENANCE
YAKIMA products should be cared for and maintained.
• To clean, use only mild detergents. Harsh
detergents could damage the product's surface.
• Remove the EXO System before entering an
automatic car wash.
• Hardware such as locks should be lubricated
with graphite or other dry-lubricants.
Instruction #1036058B - page 6 of 10
LOADING ACCESSORIES
IMPORTANT!
The arms of the EXO SwingBase™ cannot be folded in
with the EXO LitKit™ installed. We recommend removing it when not
in use so you can return your EXO SwingBase to the stowed position.
READ THESE WARNINGS!
REMOVAL
IMPORTANT!
Be sure to read all
the warnings and
w
warranty information
contained in the
insert accompanying
these instructions!
Tabla de contenido
