Travel Information; Sleepcube Dc Operation; Battery Power - DeVilbiss Healthcare SleepCube DV54 Serie Manual Del Usuario

EN
or a removed mask. Check for leak around the mask seal and make adjustments as
necessary according to the mask manufacturer's instructions. This message will be displayed
until the high airflow problem is corrected. If the high airflow condition persists for about 20
seconds, the device will automatically turn off (if AutoOFF is enabled).
Device Fault – If a device fault message is displayed, refer to
Troubleshooting for instructions.
sleePCUbe TRaVel infoRmaTion
International Power Changes
Your DeVilbiss SleepCube is equipped with a universal power supply. This means that it is
automatically capable of accepting line voltages of 100 to 240V~ 50/60Hz. You do not need
to make any adjustments to the device if you are traveling to another country where the line
voltage is different than your domestic line voltage. Simply contact your home care provider
for the correct style power cord for the region in which you will be traveling (refer to
Accessories/Replacement Items for the correct part number).
Altitude
Your SleepCube automatically compensates for changes in altitude between sea level and
9000 ft (2750 m). You do not need to make adjustments to the device for changes in
altitude.

sleePCUbe DC oPeRaTion

Battery Power

Your SleepCube can be operated from a 12V DC power source in a motor home, boat or
other recreational vehicle. The power source can be used with a 12V DC accessory cable
or a 12 V DC stand-alone battery. Both parts are available from your home care provider
(refer to Accessories/Replacement Items for the correct part numbers). Both accessory
cables are required for stand-alone battery operation. The stand-alone battery connection
uses clamps that attach to the terminal connections of the battery.
NOTe– The heater for the SleepCube's humidification system will not operate directly from a
12V DC power source. If you need humidification, non-heated humidification is still
available. Alternately, instead of connecting12V DC power directly to the SleepCube,
you can pass the DC power through an inverter that will deliver AC power to the
system. This will allow the heater to function. The power rating of the inverter must be
at least 200 watts @ 110V~ / 400 watts @ 220V~.
NOTe– The SleepCube will automatically switch power sources between AC and 12V DC if
SE-DV54-1
22
traVEl/Dc opEration
Device Fault E07
Call Provider