Special Functions; Reset Setting; Messages - LORCH M-Pro BasicPlus Manual De Instrucciones

13 .7 Special functions

Gas test
 Turn the unit OFF using main switch 9.
 Press the torch key and keep it pressed.
 Turn the unit ON using main switch 9.
9 The solenoid valve of the unit will go on
and the gas supply can be tested/adjust-
ed. The function is active for 30 seconds
and will be automatically stopped. Re-
pressing the torch key. can interrupt the
gas test.
Fan test
 Turn the unit ON using main switch 9.
9 The fan will start for function purposes.
Operation panel test
 Press the mode key 60 for at least 5 sec-
onds.
9 All operation displays will flash for approx.
20 seconds.
14

Messages

During operational faults/malfunction , the
7-segment display 47 displays an error
code.
Code Error description
no program
E00
Excessive tempera-
E01
ture
- 50 -

13 .8 Reset setting

 Turn the unit OFF using main switch 9.
 Press the mode key 60 and keep it
 Turn the unit ON using main switch 9.
9 All symbols and displays will light up
Note
Selected programme number does
not exist.
Instead of material thickness „--- "
is displayed and by pressing the
torch key „E00" shows up. Welding
is not possible at activated charac-
teristic line and set welding step.
The equipment has been over-
heated
Master reset
Attention All personal settings
i
will be lost .
All welding and secondary param-
eters are reset to their factory set-
tings.
pressed.
shortly to confirm reset.
As long as there is an error code
i
on display welding is not possible.
Messages
Rectification
Select a different char-
acteristic line
Select a different weld-
ing step
Allow the system to cool
down in standby, check
the ventilation system
10.13