GE PGP976 Instrucciones De Instalación página 13

Ocultar thumbs Ver también para PGP976:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

MAKING THE LP CONVERSION
3 CHANGE COOKTOP BURNER
ORIFICES
Remove the grates, burner caps, and burner
A
heads.
Using a 7mm nut driver, remove the burner
B
orifices. These may be accessed through the
burner holes in the cooktop.
Inner
burner cap
Burner
Outer
base
burner
cap
Electrode
Burner
base
Orifice spuds located
through these openings
Tri-Ring Burner
Retainer
Ring
Locate the LP/Propane orifices shipped inside
C
the literature package. They will have a digit
number and the letter "L" on the side.
(Important: Save the orifices removed from the
appliance for future use.)
Each orifice will show a series of engraved
marks, (I, II, III, IV or V), located on the top.
These marks denote the location of each orifice to the
cooktop burner.
I
x1
II
x2
For PGP976 Models
I
x1
II
x2
For PGP986 & CGP650 Models
See instructions
for center burner
Installation Instructions
Burner
OR
Burner
head
Burner
base
Orifice spud located
Electrode
through this opening
NOTE: On all burners, the
orifices have a spring-loaded
retaining ring around the hex
head to hold the orifice in the
nut driver during installation
and removal. A slight amount
of force is required to push the
nut driver down over the ring.
III
x1
IV
x1
III
x1
V
x1
V
x3, Tall
(CONT.)
3 CHANGE COOKTOP BURNER
ORIFICES (CONT.)
CENTER BURNER
17,000 BTU/hr Extra Large Burner (PGP976 Models)
cap
Extended spud for center
extra large burner
13
Burner
Cap
Set Screw
Choke
Burner
Head
Extended
Spud
Base
Orifice spud located
through this opening
Tabla de contenido
loading

Este manual también es adecuado para:

Pgp986Cgp650

Tabla de contenido