GB
Assembly with quick-release frame
Install the cooling unit on the quick-release frame.
3
Figure26 - Quick-release frame/switch cabinet
assembly
Procedure
Position the quick-release frame (1) on the assembly cut-out (2).
The assembly cut-outs and fastening points are identical to those for assembly of the cooling unit alone; see
figure
cut-outs for the DTT cooling unit.
Fasten the quick-release frame with screws and casement fasteners (3) on the switch cabinet from the inside;
see the figure Quick-release frame/switch cabinet assembly.
When retrofitting, use the screws and casement fasteners which fastened the cooling unit; see the figure
Loosening the front panel.
Insert the cooling unit in the quick-release frame (4).
Lock the cooling unit in the quick-release frame. Use the wrench (5) provided for this purpose.
The DTT cooling unit is attached and ready for electrical connection.
Operating Manual DTT 6401 Standard Controller (SC) 086100036 © Pfannenberg GmbH
1
2
4
Figure27 – Quick-release frame/switch cabinet/cooling
5
unit assembly
Page 24 / 42