The First Wash Cycle; Technical Data - Hotpoint Ariston BWMD 742 Manual De Instrucciones

Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity
socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
• the power supply voltage falls within the va-
lues indicated in the Technical data table (see
opposite);
• the socket is compatible with the plug of the
washing machine. If this is not the case, repla-
ce the socket or the plug.
! The washing machine must not be installed
outdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washing machine has been installed,
the electricity socket must be within easy reach.
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct supplied
to the tap (see figure).
The free end of the
hose should not be
underwater.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held respon-
sible in the event that these regulations are not
respected.

The first wash cycle

Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using the
wash cycle (60°C).

Technical data

Model BWMD 742
width 59.5 cm
height 81.5 cm
Dimensions
depth 54.5 cm
Capacity from 1 to 7 kg
please refer to the technical
Electrical
data plate fixed to the ma-
connections
chine
maximum pressure 1 MPa
(10 bar)
Water con-
minimum pressure 0.05
nections
MPa (0.5 bar)
drum capacity 52 litres
up to 1400 rotations per
Spin speed
minute
Test wash
cycles in programme
accordance press of the button);
with re- Standard Cotton 60°C.
gulations programme
1061/2010 press of the button); Stan-
and dard Cotton 40°C.
1015/2010
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electromagne-
tic Compatibility)
- 2006/95/EC (Low Voltage)
- 2012/19/EU - WEEE
GB
(60°) (1st
(40°) (2nd
3