Fanimation HF6050 Serie Manual Del Propietário página 7

How to Assemble Your Ceiling Fan (cont'd)
8. Route wires & cable through opening in Canopy. Position
Canopy on fan shown with open side facing up. (Figure 4)
9. Reinstall the Hanger Ball (Figure 3) on the Downrod
as follows. Route the three 80˝ wires through the Hanger
Ball. Position the Pin through the two holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
groove in the top of the Hanger Ball. Pull the Hanger Ball
up tight against the pin. Securely tighten the setscrew
in the Hanger Ball. A loose setscrew could create fan
wobble.
▲WARNING
It is critical that the clevis pin in the downrod support is
properly installed and the setscrews & nuts are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
10. The fan comes with black and white leads. Before
installing fan, measure up approximately 6-9 inches above
top of Downrod/Hanger Ball Assembly. Cut off excess wire
and strip back insulation ½˝ from end of wire.
11. You have now completed the assembly of your new
ceiling fan. You can now proceed with the hanging and the
electrical wiring of your fan.
Downrod/Hanger
Ball Assembly
Canopy
7
Figure 4