Selecting Sync Or Alt; Selecting Single Or Dual Color (If Equipped) - Federal Signal Spire 200 Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions
beacons, you can click the momentary switch instead of
tapping the green wire.
NOTE: When tapping the green wire to change patterns, do not
hold power for longer than one second, or other features of the
beacon will change.

Selecting Sync or Alt

When setting up devices to be synchronized, they must never
be operated without a ground connection. If a poor ground
connection exists, the unit will operate erratically and the
warranty is voided. Routinely inspect all connections to ensure
that they are secure.
The beacon can synchronize with other beacons. It will either
flash with or alternate the timing of the flashes with other
beacons. Select this feature separately for Mode 1 or Mode 2.
To synchronize your selected flash pattern:
1. Activate Mode 1 or 2.
2. Connect and hold the green wire to the positive voltage
source until the beacon pulses twice, and then release it.
The beacon switches from its initial setting to its opposite.
"Flash with" becomes "Alternate," or vice versa.
3. To synchronize, after setup, connect the green wires
together.
For this feature to operate, permanently connect all green wires
after all beacons in the system are configured.

Selecting Single or Dual Color (if equipped)

The beacon can be made to either flash a single color or two
colors. This is done separately for Mode 1 or 2.
To select single or dual color:
1. Activate the mode for which this color feature is to be set.
2. Connect and hold the green wire to the power until the
beacon pulses three times, and then release it.
16
Spire
Federal Signal www.fedsig.com
200 Beacon
™