Configuring The Beacon; Selecting A Flash Pattern - Federal Signal Spire 200 Instrucciones De Instalación Y Mantenimiento

To temporarily mount the beacon to a vehicle with magnetic
mounting or magnetic suction mounting:
1. Place the beacon on the vehicle roof at a location that
provides maximum signaling effectiveness for your
application.
2. For models with suction cups, apply downward pressure to
the top of the dome while pulling up on the release tabs to
release trapped air.
3. To operate the magnet-mounted beacon, insert the plug at
the end of the cable assembly into the 12-volt power outlet
socket. Turn the beacon on and off using the power switch
on the plug. To show that the power is on, a pilot light turns
on.
4. To remove models with a suction cup, pull up on the release
tabs while picking up the beacon.

Configuring the Beacon

If the beacon's operating functions are to be changed from the
default, perform the following steps.

Selecting a Flash Pattern

LIGHT HAZARD: This product contains a high intensity LED
device. To prevent permanent eye damage, DO NOT stare into
the light beam at close range.
Selecting a flash pattern from the beacon's internal library of
flash patterns is optional. It should be done during installation.
For available flash patterns, see Table 4 on page 18.
To select a flash pattern:
1. Select the Mode 1 (red wire) or Mode 2 (white wire).
2. Apply power (+12-24 Vdc) to that wire.
3. To activate FSLink, tap the green wire to + 12-24 Vdc until
desired pattern is reached. For magnetically mounted
Spire 200 Beacon
™
Federal Signal www.fedsig.com
Installation and Maintenance Instructions
15