Charging The Battery Pack (See Fig. A); Dust/Chip Extraction; Connecting A Dust Extraction Unit - Parkside PAMFW 20-Li A1 Traducción Del Manual De Instrucciones Original

Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
■ Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket.
The control LED
♦ The green LED indicates that the charging
process is complete and the battery pack
ready.
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
defective.
WARNING! RISK OF INJURY!
■ Always remove the battery before working on
the power tool.
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
PAMFW 20-Li A1
to the high-speed
(see Fig. A).
lights up red.
flashes, this means
has overheated and
both
into the appliance.

Dust/chip extraction

Materials containing asbestos must not be
processed. Asbestos is a known carcinogen.
WARNING! RISK OF FIRE!
■ When working with electrical appliances
which can be connected to a vacuum cleaner
via a vacuum cleaner adapter, there is a risk
of fire! In unfavourable conditions, e.g. when
sparks are flying while sanding metal or
metal residues in wood, wood dust in the bag
of the vacuum cleaner can spontaneously ig-
nite. This is a particular risk if the wood dust is
mixed with paint residues or other chemicals
and the workpiece has become hot after be-
is
ing worked for a long time. Therefore, avoid
overheating of the material being sanded
as well as the appliance. Always empty the
vacuum cleaner's dust bag before taking
work breaks.
■ Always use dust extraction.
■ Ensure that your workplace is adequately
ventilated.
is
■ Observe the regulations applicable in your
country regarding the materials to be worked.

Connecting a dust extraction unit

♦ Place the dust extraction unit
ance and fix it into place on the appliance with
the screw.
♦ Fit the angle adapter
unit .
The angle adapter
180°.
under the appli-
onto the dust extraction
can be turned by up to
GB │ IE │
21 ■