Operation; Preparing For Start-Up - Husky C602H Guía De Uso Y Cuidado

Operation

1

Preparing for start-up

WARNING: Risk of unsafe operation. Firmly grasp air
hose in hand when installing or disconnecting to prevent
hose whip.
WARNING: Risk of unsafe operation. Do not use damaged or worn accessories.
WARNING: Risk of bursting. Too much air pressure
causes a hazardous risk of bursting. Check the
manufacturer's maximum pressure rating for air tools and
accessories. The regulator outlet pressure must never
exceed the maximum pressure rating.
CAUTION: Risk of unsafe operation. Compressed air
from the unit may contain wa ter condensation and oil
mist. Do not spray un fil tered air at an item that could be
damaged by moisture. Some air tools and accessories may
require filtered air. Read the in struc tions for the air tools
and accessories.
NOTE: A regulator MUST be installed when using
accessories rated at less than 150 psi. The hose or
accessory will require a quick connect plug if the air outlet
is equipped with a quick connect socket.
□
Turn the AUTO ( I ) / OFF ( O ) switch (1) to the
OFF ( O ) position.
□
Close the drain valve (2).
□
Visually inspect air lines and fittings for leaks.
2
Starting the compressor
WARNING: Risk of bursting. If any unusual noise or
vibration is noticed, stop the air compressor immediately
and have it checked by a trained service technician.
NOTE: When using the regulator and other accessories,
refer to the manufacturer's instructions.
□
Plug the power cord into a proper receptacle.
□
Turn the AUTO ( I ) / OFF ( O ) switch (1) to the
AUTO ( I ) position, and allow the tank pressure
to build. The motor will stop when the tank
pressure reaches "cut-out" pressure.
16
1
2
1
2