Operation - Husky H1503TP Manual Del Operador

Operating air powered tools requiring up to 2.5 SCFM.
Inflating tires, air beds, sports equipment, etc.
USING THE AIR COMPRESSOR
See Figures 7A - 7B
See figures 8A - 8B
Ensure tank drain is closed.
Ensure tank drain is closed.
Turn regulator knob counter clockwise until outlet Turn regulator knob counter clockwise until outlet
pressure is at zero (0).
pressure is at zero (0).
Ensure power switch is in the OFF (0) position and air
Ensure power switch is in the OFF (0) position and air
compressor is unplugged.
compressor is unplugged.
If not ready installed, attach hose to compressor as
If not already installed, attach hose to compressor as
previously instructed.
previously instructed.
Attach 1/4 in. NPT male connector fitting to accessory
Attach 1/4 in. NPT male quick connect plug to accessory
or tool you intend to use.
or tool you intended to use.
Insert the other and of the male connector to the quick
Insert the other end of the male quick connect plug to
coupler on the open end of hose
the quick coupler on the open end of hose.
Always ensure the swith is in the OFF (O) position and
the regulator pressure gauge reads zero before chang-
ing air tools or disconnecting the hose from the air
outlet. Failure to do so could result in possible serious
personal injury.
Connect the power cord to the power supply.
Turn the switch ON (I) and allow tank pressure to build.
All manuals and user guides at all-guides.com

OPERATION

AIR CHUCK
ACCESSORIES
Check the air tool manual to insure the correct air
If you are using an air tool not originally included with
pressure regulator setting for optimum operation of
the air tool kit supplied with this air compressor, your
your air tools. If you arre using an air tool not originally
tool may require more air consumption than this air
included with the air tool kit supplied with this air
compressor is designed to supply.
compressor, your tool may require more air consumption
than this air compressor is designed to supply.
Always read your air tool owner's manual to match the
Always read your air tool owners manual to match the
correct air supply to your air tool to avoid damage to the
correct air supply to your air tool to avoid damage
tool or risk of personal injury.
to the tool or risk of personal injury.
14
THREAD
¼" MALE QUICK
SEALING
CONNECT PLUG
TAPE
THREAD
SEALING
TAPE
INFLATION
¼" MALE QUICK
CONNECT PLUG
INFLATION THREAD
THREAD
ADAPTER SEALING
SEALING
TAPE
TAPE
Rotate pressure regulator knob to desired line pres-
sure. Turning the knob clockwise increases air pres-
sure at the outlet; turning countercolockwise reduces air
pressure at the outlet.
Following all safety precautions in this manual and the
manufacturer's instructions in the air tool manual, you
may now proceed to use your air-powered tool.
WARNING:
If using an inflation accessory, control the amount of air
flow with the pressure regulator knob. Turning the knob
fully counterclockwise will completely stop the flow of
air.
NOTE: Always use the minimum amount of pressure
necessary for your application. Using a higher pressure
than needed could cause serious injury and may
permanently damage the tool.
When finished, always drain the tank and unplug the
unit. Never leave the unit plugged in and/or running
unattended.
HOSE WITH QUICK
COUPLER ATTACHED
Fig. 7A
Fig. 8A
HOSE WITH QUICK
COUPLER ATTACHED
Fig. 8B
Fig. 7B