Programming, Firmware Update; Maintenance; Periodic Inspection, Cleaning; Power Source Fittings, Commands And Signals - Cebora SYNSTAR 200 M Manual De Servicio

Ocultar thumbs Ver también para SYNSTAR 200 M:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

2.4

Programming, firmware update.

The power source programming or firmware updating are
possible by "Cebora Device Manager".
"Cebora Device Manager" is a program, downloadable
from the Cebora web site http://www.cebora.it, that has
to be installed into a PC with Windows operating sys-
tem, equipped with RS232 serial port or appropriate USB
adapter.
By connecting the PC to the power source H1 connector
(the BD1 connector on panel board (48)), is possible to
program the power source, other than performing the di-
agnostic capabilities of the program.
The H1 connector is accessible from the power board (45)
compartment by removing the lateral panel 12 (see Fig.
3.2.a and 4.1).
In the Cebora web site are available the program files to
install in the equipments (files named *.ceb or *.fwu) and
the Instructions Manual to help in using Cebora Device
Manager.
EN
20
3

MAINTENANCE.

WARNINGS
ANY INTERNAL INSPECTIONS OR REPAIRS MUST
BE CARRIED OUT BY QUALIFIED PERSONNEL.
BEFORE BEGINNING MAINTENANCE OPERA-
TIONS, UNPLUG THE MACHINE FROM THE MAINS
AND WAIT FOR THE INTERNAL CAPACITORS TO
DISCHARGE (1 MINUTE).
3.1

Periodic inspection, cleaning.

Periodically make sure that the equipment and all connec-
tions are in proper condition to ensure operator safety.
Periodically open the power board (45) protection carter
and check inside the ventilation tunnel.
Remove any dirt or dust to ensure smooth air flow and
thus adequate cooling of the internal parts of the power
source.
Remove any dirt or metal dust from the wire feed liner and
gearmotor unit, making sure that they are not worn to the
point of needing replacement.
Check the condition of the output terminals, output
and power supply cables of the power source; replace if
damaged.
Check the condition of the internal power connections and
connectors on the electronic boards; if you find "loose"
connections, tighten or replace the connectors.
3.2

Power source fittings, commands and signals.

See Fig. 3.2.a, 3.2.b and power source Instructions Manual.
3.3
Troubleshooting.
NOTE
Items in boldface describe problems that may occur on
the machine (symptoms).
□ Operations preceded by this symbol refer to situations
the operator must determine (causes).
■ ♦ Operations preceded by these symbols refer to ac-
tions the operator must perform in order to solve the
problems (solutions).
3302316/A
Tabla de contenido
loading

Este manual también es adecuado para:

322

Tabla de contenido