Wall Installation - THERMEx TX MOTOR Instrucciones De Montaje

M P528217000011102016

WALL INSTALLATION

The TX motor for wall mounting (P528.19.9108.0) is delivered fastened to a plate and with a
shield mounted. Start by removing the shield. This is done by removing the 8 screws holding the
shield on the motor.
Afterwards, the hood is installed on the wall according to the following steps:
1
x1
x1
Measure out and drill the hole for the flue.
3
x4
Measure out and mark the holes for the
motor.NOTE: The motor should be
positioned vertically and the air outlet
downward.
THERMEX TX MOTOR 49
2
Install the duct in the hole.NOTE: It is
important that the none-return valve
turns with flaps standing vertically.
4
x4
x4
Drill the holes and install rawlplugs
suitable for the material into which they
are installed.