Installation - THERMEx CAVE Instrucciones De Montaje

M 540235191210082018

INSTALLATION

The hood is available with an internal motor or for installation with an external motor. The kitchen hood can be used with the exhaust venting
into the open air or for recirculation of air.
Follow the instructions in this manual that correspond to the model you have purchased.
INSTALLATION OF THE HOOD
The two keyhole brackets on the back of the hood can be used for hanging the hood.
The installation can be carried out in the following way:
1
Measure out and mark the position of the
two keyholes.
4
NOTE: The screws must not be screwed in
further than the hood can be installed.
7
Mark the position of the locking holes.
NOTE: Steps 7-11 only apply if the hood has
locking holes.
2
x2
Drill the holes into the wall using a suitable
drill for the type of wall.
5
Hang the hood on the screws.
8
Pre-drill the holes and insert the rawlplugs.
3
x2
Ensure that the rawlplugs and screws are
suitable for the wall material in question and
insert them into the pre-drilled holes.
6
Open the glass door and remove the filters.
9
x2
Re-hang the hood.
THERMEX CAVE 37
x2
x2