Device Elements; Start Up; Dry Vacuum Cleaning; Wet Vacuum Cleaning - Kärcher NT 35/1 Guia De Inicio Rapido

Device elements

1 Electrodes
2 Suction hose
3 Cable hook
4 Air outlet, working air
5 Suction head lock
6 Air inlet, motor cooling air
7 Suction head
8 Steering roller
9 Dirt receptacle
10 Suction support
11 Floor nozzle
12 Suction tube
13 Carrying handle
14 Filter cover
15 Bender
16 Automatic filter dedusting
17 Main switch
18 Flat fold filter
19 Filter dedusting
20 Floor nozzle holder
21 Holder for crevice nozzle
22 Holder for suction pipes
23 Power cord
24 Nameplate

Start up

ATTENTION
The flat pleated filter must always be in
place while vacuuming.

Dry vacuum cleaning

– To vacuum up fine dust, a fleece filter
bag or a membrane filter (special ac-
cessory) can additionally be used.
Install fleece filter bag
Illustration
 Release and remove the suction head.
 Insert the fleece filter bag.
 Insert and lock the suction head.
Install membrane filter
Illustration
 Release and remove the suction head.
 Pull the membrane filter (option) over
the container edge.
 Insert and lock the suction head.
8
Changeover from wet to dry vacuum
cleaning
ATTENTION
Please note the following when switch-
ing from wet to dry vacuum cleaning:
If you vacuum dry dust while the filter element
is still wet the filter will become obstructed
and may be damaged beyond repair.
 Dry the wet filter properly before use or
replace it with a dry one.
 Change the filter, if required, according
to instructions under the section "Main-
tenance and Care".
Note: For permanent wet vacuum cleaning
it is advisable to use a PES flat pleated filter
(see filter systems).

Wet vacuum cleaning

Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Removing the fleece filter bag/
membrane filter
– If the appliance is used to vacuum up
wet dirt, the fleece filter bag or the mem-
brane filter (special accessory) must al-
ways be removed.
– It is recommended to use a special filter
bag (wet) (see Filter systems).
General
– If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– 2
EN