Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
To remove contaminants from the pump, follow
these steps:
1.
Set up the pressure washer as described in "Preparing
Pressure Washer For Use". Connect the water supply
and turn water on.
2.
Remove the nozzle extension from the spray gun.
3.
Start the engine according to instructions in "How To
Use Your Pressure Washer".
4.
Squeeze the trigger on the spray gun and hold.
5.
When the water supply is steady and constant, engage
the safety latch and refasten the nozzle extension.
Check In-Line Filter
Refer to Figure 13 and service the in-line filter if it
becomes clogged, as follows:
Figure 13 — Clean In-Line Filter
Nozzle Extension
2.
If the screen is damaged, the o-ring kit contains a
replacement in-line filter screen and an o-ring. If
undamaged, reuse screen.
3.
Place the in-line filter screen into the threaded end of
the nozzle extension. Direction does not matter. Push
the screen in with the eraser end of a pencil until it
rests flat at the bottom of the opening.Take care to
not bend the screen.
4.
Place the o-ring into the recess. Push the o-ring snugly
against the in-line filter screen.
5.
Assemble the nozzle extension to the spray gun, as
described earlier in this manual.
Nozzle Maintenance
A pulsing sensation felt while squeezing the spray gun
trigger may be caused by excessive pump pressure.The
principal cause of excessive pump pressure is a nozzle
clogged or restricted with foreign materials, such as dirt,
etc.To correct the problem, immediately clean the nozzle
using the tools included with your pressure washer and
follow these instructions:
1.
Shut off the engine and turn off the water supply.
Speed Clean™ 2300 PSI Pressure Washer
Filter Screen
O-ring
www.mymowerparts.com
2.
Detach the nozzle extension from the spray gun.Twist
the nozzle clockwise to the stream position. Using the
supplied 2mm (5/64) allen wrench, remove the orifice
from the end of the nozzle extension (Figure 15).
Figure 15 — Removing and Cleaning Orifice
3.
Remove the in-line filter from the other end of the
nozzle extension.
4.
Use the wire included in the kit (or a small paper clip)
to free any foreign material clogging or restricting the
orifice (Figure 15).
5.
Using a garden hose, remove additional debris by back
flushing water through the nozzle extension
(Figure 16). Back flush between 30 to 60 seconds.Turn
the adjustable nozzle extension to stream spray and
move the nozzle from low to high while flushing.
Figure 16 — Backflushing the Nozzle
6.
Reinstall the orifice and in-line filter into the nozzle
extension. DO NOT overtighten the orifice with the
allen wrench.
7.
Reconnect the nozzle extension to the spray gun.
8.
Reconnect the water supply, turn on the water, and
start the engine.
9.
Test the pressure washer by operating with nozzle in
the high and in the low positions.
12
Orifice
Capítulos
Tabla de contenido
