Installing And Charging The Battery - Konrow Slider Guia Del Usuario

1. Inserting a SIM card
2. Inserting a MicroSD
It is possible to increase the internal memory of the
Slider device with a MicroSD card (maximum 32GB
MicroSD card).
• Switch off the phone and remove the rear cover
and battery.
• Insert the memory card into the relevant slot.
• Then replace the battery and cover.
CAUTION: Inserting or removing a SIM card or a MicroSD
card requires the mobile to be completely switched off.

3. Installing and charging the battery

Installing the battery:
• Remove the rear cover of your mobile.
• Insert the battery ensuring that the image shown here is facing you.
• Replace the rear cover of the mobile.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Model: Slider Li-ion
Battery 3.7V / 800 mAh.
To replace the battery, please enquire with the after-sales service of your dealer. Dispose of
used batteries according to the instructions.
Charging the battery:
• To charge the battery, connect the USB cable (supplied) to the USB port of your mobile
then connect the mains adaptor to a power outlet.
• The battery charge icon illuminates during charging and indicates the charge status.
• When the battery is fully charged, you can disconnect the USB cable from the device
then from the power outlet.
• IMPORTANT:
• The mobile is only recharged via its USB port.
• Ensure your mobile is fully discharged before charging it for the first time.
• The battery must be charged for at least 5 to 8 hours when first charged.
Note: You can use the device when it is being charged. In this case, the battery may take
longer to charge fully.
Slider is a mobile phone with dual SIM card which en-
ables you to use two lines on the same mobile. Your Sli-
der has two standard SIM ports. To insert the SIM card(s):
• Switch off the phone and remove the rear cover
and battery.
• Insert the SIM card correctly into the relevant card
slots (see figure below).
• Then replace the battery and cover.
Set up
EN