Maintenance And Cleaning; Cleaning; Maintenance; Procedure Replacing Vari-Drop™ And Air Cylinder - Henkel Loctite Shot Miser Manual De Operación

6. Maintenance and Cleaning

6.1 Cleaning

The product dispensing section of the Loctite
Flushing Solvent supplied from a suitable reservoir. Adjust the reservoir pressure to a low value to
reduce the flow rate.

6.2 Maintenance

There are two main components, the air cylinder and the Vari-Drop™ applicator that can be
replaced.
6.2.1 Procedure for Replacing Vari-Drop™ and Air Cylinder
Caution!
• Before starting the replacement procedure make sure that the product reservoir pressure is
(0) psig.
• Detach the Loctite
• Drain any product from the Loctite
a level higher than the product reservoir. Actuate the Loctite
the product down into the product reservoir.
• Shut off the control air pressure to the Loctite
• Disconnect the control air line from the fitting on the air cylinder.
• Disconnect the product supply tube from the Loctite
• Secure the tubes in a safe manner so there is no siphoning from the product supply tube and
no whipping from the control air tube if the air is accidentally turned on.

6.2.2 Disassembling the Loctite

10
® Vari-Drop™ from any mounting bracket.
®

Vari-Drop™

Vari-Drop™
Remove the #10-32
Nuts and Screws
Henkel Loctite Corp.
Air Cylinder
Cilindro De Aire
# 986131
® Vari-Drop™ can be flushed with Loctite
® Vari-Drop™ by elevating it and the product supply tube to
Vari-Drop™.
®
® Vari-Drop™.
Luer-Lok Adapter
Figure 5.
® Equipment
® Vari-Drop™ and let gravity move
Remove the Valve
Remove the Cover
Shot Miser™
Dispense Valve
Válvula Dosificadora
# 98085
Replacement Parts:
Refacciones:
Vari-Drop™ Valve / Válvula:
# 97132
Air Cylinder / Cilindro De
Aire:
# 986131