Connecting The Air Line; Product Supply Tube; Installing The Anti-Bubbler; Dispense Tip - Henkel Loctite Shot Miser Manual De Operación

4. Installation (continued)
4.2 Connecting the Air Line / Reference – Figure 1
Loctite
• Connect the foot pedal, as shown in Figure 1, to the valve controller.
• Connect 4 mm air line from the normally not passing port, first the air line connection from front
of controller, then to the air cylinder on the dispense valve.
• Insure that normally passing port has port plug installed (second air line connection from front
of controller).
• Connect the supply air to "Air In Port" on valve controller.
• Connect the supply air to "Air In Port" on reservoir.

4.3 Product Supply Tube

• Note that this is a Teflon • Slide the nut and ferrule onto the product supply tube.
• Push the end of the product supply tube into the Vari-Drop™. Make sure that the end of the
product supply tube bottoms out in the Vari-Drop™.
• Position the nut and ferrule and tighten the fitting nut 1 to 1
• Connect the other end of the product supply tube to the product pressure reservoir as stated in
"Install Anti-Bubbler".
4.4 Installing the Anti-Bubbler to .5 liter and 2 liter Reservoirs
Anti-Bubbler
The anti-bubbler is inserted at the end of the feedtube which resides in the product reservoir. The
purpose of the anti-bubbler is to minimize the amount of adhesive which will run out of the
feedtube when the reservoir lid is removed to re-fill the product reservoir.
A. Anti-bubbler Installation -
Install the spring guard, the fitting nut, and the ferrule onto the feedline. Insert the feedline into the
fitting located in the reservoir lid. Insert the anti-bubbler into the anti-bubbler connection sleeve.
Push the anti-bubbler connection sleeve onto the
anti-bubbler is close to the bottom of the adhesive bottle.
B. Anti-bubbler Installation -
Install the spring guard, the fitting nut, and the ferrule onto the feedline. Insert the feedline into the
fitting located in the reservoir lid. Insert the anti-bubbler into the
so that the anti-bubbler is close to the bottom of the adhesive bottle.

4.5 Dispense Tip

• Position a suitable dispense needle in the Luer-Lok adapter and tighten securely.
8
® Shot Miser™ Dispense System
® lined tube.
1 ⁄
Feedline to Valve
3 ⁄
Feedline to Valve
" Feedtube
4
1 ⁄ " feedline. Position the feedline so that the
4
" Feedtube
8
⁄ turns past finger tight.
1
2
Connection Adapter
Sleeve
3 ⁄ " feedline. Position the feedline
8
Adapter