Tabla de contenido
Idiomas disponibles
Idiomas disponibles
to weld a ring or the like to metal causing a severe burn.
PREPARING TO TEST
1.
Be sure area around battery is well ventilated while
battery is being tested.
2.
Clean battery terminals. Be careful to keep corrosion
from coming in contact with eyes.
3.
Inspect the battery for cracked or broken case or cover. If
battery is damaged, do not use tester.
4.
If the battery is not sealed maintenance free, add distilled
water in each cell until battery acid reaches level
specified
by
excessive gas from cells. Do not overfill.
5.
If necessary to remove battery from vehicle to test,
always remove ground terminal from battery first. Make
sure all accessories in the vehicle are off to ensure you
do not cause any arcing.
OPERATION & USE
BATTERY TEST
1.
Before you test a battery in a vehicle, turn off the ignition,
all accessories and loads. Close all the vehicle doors
and the trunk lid.
2.
Make sure you have put 1.5V*4pcs batteries into the
battery chamber. If the 1.5V battery runs out of power,
screen will show " REPLACE INTERNAL BATTERY" or
"POWER LOW". Replace those 1.5V*4pcs batteries
before starting the test.
Note that nothing will be seen on the display until
the tester is connected to a vehicle battery.
3.
Make sure the battery terminals are clean. Wire brush
them if necessary. Clamp the black load lead to the
vehicle negative battery terminal. Clamp the red load
the
manufacturer.
- BT701/BT747
- GB.3-V1 -
This
helps
purge
Tabla de contenido
