Oven Care And Cleaning; Clean; Removing The Door - BORETTI BPON 45 Instrucciones

18 - Oven Care and Cleaning

EN
Abrasive detergents and steam cleaning equipment should not
be used for cleaning.
WARNING
Do not use harsh abrasive cleaners or sharp metal scrapers
to clean the oven door glass since they can scratch the
surface, which may result in shattering of the glass.

Clean

Assisted cleaning
High temperature cycle (250°C), combined with self-cleaning
panels for gentle, non-invasive cleaning of the cooking
chamber.
Correct operation is combined with the use of the lateral
panels and catalytic fan cover: the oven is treated with special
enamel with a micro-porous structure, which breaks down the
fat projected thanks to a catalytic oxidisation process which
transforms residues into gaseous products.
The turbo clean function is only activated when no cooking
function has been selected, so: switch on the oven and touch
the symbol as shown in the figure for five seconds.
WARNING
The cleaning process takes place at a temperature of 250°C
and lasts one hour. Do not use it for cooking food!!
The oven light is activated and can be switched off and on
again at any time.
All the self-cleaning panels will perform effectively for thirty
cleaning processes, after this limit the panels must be replaced.
The panels should be cleaned exclusively with tap water and
replacements can be ordered from your specialised dealer.
32

Removing the door

WARNING
Make sure that:
• The oven is cool and power to the oven has been turned
off before removing the door. Failure to do so could result
in electrical shock or burns.
• The oven door is heavy and fragile. Use both hands to
remove the oven door. The door front is glass. Handle
care-fully to avoid breakage.
• Grasp only the sides of the oven door. Do not grasp the
handle as it may swing in your hand and cause damage
or injury.
• Failure to grasp the oven door firmly and properly could
result in personal injury or product damage.
Removing the standard oven door
The oven door can be removed quickly and easily. To do so,
proceed as follows:
• Open the door fully.
• Lift the two levers shown below.
• Close the door as far as the first stop (caused by the raised
levers).
• Lift the door upwards and outwards to remove it fromits
mountings.
To replace fit the door, fit the hinges in their mountings and
lower the two levers