Information For The Installer - FAAC TM2 X TT-50 Manual De Instrucciones

INFORMATION FOR THE INSTALLER

ATTENTION! Even if the TM2 X TT-50 remote control can be used for all
installation devices, it is advisable to use also other remote controls (single or
multi-channel ones) in order to control the devices in case of emergency (e.g.
fl at batteries). Alternatively, we suggest using a wire remote control.
Programming the LIMIT-SWITCHES and the MIDDLE POSITION
The limit switches and the middle position of the stored devices
can be programmed using the same sequence of keys as those
used for other remote controls. The UP/STOP/DOWN commands
correspond to the A/B/C ones.
Programming the LIMIT-SWITCHES (only for installers)
How to make the programming accessible:
- Deactivate the "Program Lock" (see SETTINGS), if it is active
- Path: Main menu / Commands / Devices / CREATED DEVICE
- Press the keys in the necessary sequence according to the instructions for using the
motor.
Programming the MIDDLE POSITION
How to make the programming accessible:
- Deactivate the "Program Lock" (see SETTINGS), if it is active.
- Path: Main menu / Commands / Devices / CREATED DEVICE.
- Move the device (rolling shutter/awning) to the desired position and then hold the middle
key down (for about 4 sec.) until the motor performs the confi rmation movements.
Deleting the MIDDLE POSITION
If you want to delete the intermediate position, it can be done as described below.
To change this position, it's also necessary to delete fi rst the memorised intermediate
position.
How to make the programming accessible:
- Deactivate the "Program Lock" (see SETTINGS), if it is active.
- Path: Main menu / Commands / Devices / CREATED DEVICE.
- Command: "Middle Position".
- When the device (rolling shutter/awning) has reached the middle position, press STOP
again (for abt. 4 seconds) until the motor performs the confi rmation movements.
TM2 X TT-50
B
4 sec
35
A
B
C
A4518_6H04_Rev.A