Programming - FAAC TM2 X TT-50 Manual De Instrucciones

How to change the pre-set value:
Main menu / Settings / Radio
Set the desired values*, then press SAVE.
* Use the UP/DOWN keys to set the required value.
Press SELECT to move from one box to the other inside the same screen.
PROGRAM LOCK
In order to avoid involuntary changes to the programming, it is possible to activate
the "Program Lock" during the daily use of the remote control. When the "Program
Lock" is active, the SELECT key must be kept pressed for 4 seconds in order to make
the PROGRAMMING section accessible from the main menu. Once the lock has been
"released", the PROGRAMMING section normally remains accessible until the next time
you switch the remote control off for a long time.
How to activate/deactivate the lock:
Main menu / Settings / Progamm lock
Move to the desired option using the UP/DOWN keys, then press SELECT + SAVE.
ATTENTION!
If the "program lock" is active (see PROGRAM LOCK), you must keep the
middle key pressed for 4 seconds in order to make this section accessible.
DEVICES
How to create a new device:
Main menu / Programming / Devices / NEW
- "Name": in order to customize the device name (maximum 16 characters).
Create the required name using the keyboard. To quit: ENTER.
- "Type": to classify the device (blind, awning, etc.). After selecting, the system
automatically goes back to the screen "NEW DEVICE". To quit: BACK.
To save the device created: SAVE.
TM2 X TT-50
Advisable for daily use!

PROGRAMMING

27 A4518_6H04_Rev.A