FAAC TM2 X TT-50 Manual De Instrucciones página 28

STORING OF THE FIRST REMOTE CONTROL
ATTENTION! This programming is only necessary when the receiver (motor or control unit)
is installed for the fi rst time, that is to say, when the receiver has not yet been connected
to any remote control.
Otherwise, see: "STORING OF OTHER REMOTE CONTROLS".
make sure that the receiver (motor or control unit) is powered.
-Main menu / Programming / Devices / DEVICE CREATED / Store + STORE.
- After storing, use the UP / DOWN / STOP keys to check whether the motor is operating
correctly.
- After checking, press END PROCEDURE.
STORING OF OTHER REMOTE CONTROLS
Consult the following scheme in order to fi nd the procedure that meets your requirements:
To add:
TM2 X TT-50
Another
remote control
TM2 X TT-50
- LEGEND:
Tn / Cn: already stored remote control / channel (not LCD)
Tx / Cx: remote control / channel to be stored (not LCD)
LCDx: device to be stored on a LCD remote control
LCDn: device already stored on a LCD remote control
TM2 X TT-50
Before proceeding
To another device
created using:
Another
remote control
TM2 X TT-50
(another) TM2 X TT-50 ADD TO +
Fun
Tn/Cn
ADD FROM TM2 X T
A+B; B
LCDn
ADD TO TM2 X TT-50
ADD TO
LCDn
TM2 X TT-50
ADD FROM
ADD TO
28
PROCEDURE:
LCDx
TM2 X TT-50
ADD FROM
Tx/Cx
TM2 X T
B (2 sec)
LCDx
TM2 X TT-50
ADD FROM
A4518_6H04_Rev.A
1
2
3