Using The Air Conditioner; Cool Mode; Energy Saver Mode - GE AHE18 Manual Del Propietario Y Instrucciones De Instalación

Using the Air Conditioner

Remote Control
To ensure proper operation, aim the remote control at the
signal receiver on the air conditioner.
the remote control that could block the signal.
The remote control signal has a range of up to 20 feet.
Heat Mode
86°F in 1°F increments.

Cool Mode

Cool mode at Low, Med, High or Auto Fan
Speed
between 61°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will
become cooler. Set the thermostat at a higher number
and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan setting
to a Cool
the compressor to start and cooling to begin.

Energy Saver Mode

Controls the fan.
ON—The fan will cycle on and off with the compressor.
This results in wider variations of room temperature and
humidity. Normally used when the room is unoccupied.
NOTE: The fan may continue to run for a short time after
the compressor cycles off.
49-7795
indicated on the remote control.
surfaces.
An electronic thermostat is used to maintain the room
temperature. The heater will cycle on and off to keep the
room at the set level of comfort.
Cooling Descriptions
For Normal Cooling—Select the Cool mode and
High or Med fan with a middle set temperature.
For Maximum Cooling—Select the Cool mode
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling—Select the
Cool mode and Low fan with a middle set temperature.
OFF—The fan runs all the time, while the compressor
cycles on and off.
5