Using The Air Conditioner; Cool Mode - GE AHE18 Manual Del Propietario Y Instrucciones De Instalación

Using the Air Conditioner

Control Panel Lights On/Off Feature
feature where its lights will turn off when there is no
activity with the controls for over one minute. To wake
up the controls, press any pad on the controls and the
lights will come on to show the previous settings.
Remote Control
To ensure proper operation, aim the remote control at the
signal receiver on the air conditioner.
The remote control signal has a range of up to 20 feet.

Cool Mode

Low, Med, High or Speed for
Temperature
pads to set the desired temperature between 64°F
and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will
become cooler. Set the thermostat at a higher number
and the indoor air will become warmer.
NOTE: Do not operate in freezing outdoor conditions. The
cool mode function on this air conditioner was not designed
for freezing outdoor conditions. It must not be used when
the outdoor temperature is below freezing (32°F).
Eco Mode
Controls the fan.
ON—The fan will cycle on and off with the compressor.
This may result in wider variations of room temperature
and humidity. NOTE: the fan may continue to run
for a short time or may pulse intermittently after the
compressor cycles off to sample the room air.
OFF—The fan runs all the time, while the compressor
cycles on and off.
Fan Only Mode
to provide air circulation and filtering without cooling.
Since fan-only settings do not provide cooling, a Set
Auto Fan Mode
Set to Auto for the fan speed to automatically set to the
speed needed to provide optimum comfort settings with
the set temperature.
Heat Mode
pads to set the desired temperature between 61°F and
86°F in 1°F increments.
49-7839
To turn this feature off, press and hold the Sleep pad,
on the unit, for 5 seconds. The unit will beep to signal
the successful toggle of the feature on and off.
Make sure nothing is between the air conditioner and the
remote control that could block the signal.
Make sure batteries are fresh and installed correctly as
indicated on the remote control.
NOTE: If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan setting
to a Cool
the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the Cool mode and
High or Med fan with a middle set temperature.
For Maximum Cooling—Select the Cool mode
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling—Select the
Cool mode and Low fan with a middle set temperature.
NOTE: Do not operate in freezing outdoor conditions. The
eco mode function on this air conditioner was not designed
for freezing outdoor conditions. It must not be used when
the outdoor temperature is below freezing (32°F).
temperature cannot be entered. The room temperature
will appear in the display.
If the room needs more cooling or heating, the fan speed
will automatically increase. If the room needs less cooling
or heating, the fan speed will automatically decrease.
An electronic thermostat is used to maintain the room
temperature. The heater will cycle on and off to keep the
room at the set level of comfort.
5