Petsafe PPA11-10915 Manual De Instalación página 8

4F. You are now ready to work from the outside wall.
Line up the three holes on the template with the
three holes that you just drilled. Check for square
and tape in position.
4G. Drill out the four corners of the rectangular hole with
a 5⁄16" (8 mm) drill bit.
Helpful Tip: Use both hands to hold drill steady and
straight at a 90° angle.
4H. Carefully cut the hole out using a jigsaw or other
appropriate cutting device. Cut on line.
Helpful Tip: When cutting use both hands to hold the saw slow,
steady and straight at a 90° angle.
Helpful Tip: If you are going through vinyl siding it is best
to carefully score and cut the siding before cutting through
plywood.
Fit
4I. Using the B side of the pet door, check the fit. Do not
Check
force fit if it is tight. If the hole is too small, simply remove the
pet door and re-cut or file the hole slightly to enlarge. Do
not cut more than ⅛" (3.2 mm) from your previous cut.
Once the pet door properly goes into the hole, adjust to
ensure the unit is square.
www.petsafe.net
4F
4H
4I
4G
7