Overal Dimensions; Mounting Of The Boiler; Electrical Connections - Ecoflam MAX GAS 350 P Manual De Instrucciones

420010563501 Max Gas 350 - 500 P/P AB
EN
E
MODEL
MAX GAS 350
MAX GAS 500
All burners factory tested at 230V 50 Hz monophase (Max Gas 350) or 400 V 50 Hz three-phase (Max Gas 500) for
motors and 230V 50 Hz monophase for auxiliary equipment. If mains supply is 230 V 50 Hz threephase withuot neu-
tral, change position of connectors on burner as in fig. Protect burner supply line with safety fuses and any other devi-
ces required by safety standards obtaining in the country in question.
Once connected the burner to the gas pipeline, it is necessary to control that this last is perfectly sealed. Also verify that
the chimney is not obstructed. Open the gas cock and carefully bleed the piping through the pressure gauge connector,
then check the pressure value trough a suitable gauge. Power on the system and adjust the thermostats to the desired
temperature. When thermostats close, the sealing control device runs a seal test of valves; at the end of the test the bur-
ner will be enabled to run the start-up sequence.
OVERALL DIMENSIONS
D-D1
N
A B C D
414 277 137 175
414 277 137 175
D = SHORT HEAD
MOUNTING TO THE BOILER

ELECTRICAL CONNECTIONS

CONNECTION TO THE GAS PIPELINE
A
B C
O
D1 E F G
335 466 157 280 185/200 185/200 M8
335 466 157 280 185/200 185/200 M8
D1= LONG HEAD
16
M
I L M N
62
62
I
O
101
101