Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To change the lock code, select Menu > Settings > Config. > General > Security > Phone and
SIM card > Lock code. Enter the old code and then the new code twice. The new code can be
4-255 characters long.
To set a time-out after which the device is automatically locked and can be used only if the
correct lock code is entered, select Menu > Settings > Config. > General > Security > Phone
and SIM card > Phone autolock period. Enter a number for the timeout in minutes, or select
None to deactivate the autolock period.
When the device or keypad is locked, calls may be possible to the official emergency number
programmed into your device.
■
Antenna locations
Your device has four antennas: cellular antenna, Bluetooth antenna, WLAN
antenna, and GPS antenna. The antennas are integrated, and located at the
upper and lower parts of your device.
Note: Your device may have internal antennas. As with any radio
transmitting device, avoid touching the antenna area unnecessarily while the
antenna is transmitting or receiving. Contact with such an antenna affects the
communication quality and may cause the device to operate at a higher power level
than otherwise needed and may reduce the battery life.
■
Connect a compatible headset
Do not connect products that create an output signal as this may
cause damage to the device. Do not connect any voltage source to
the universal headset connector.
When connecting any external device or any headset, other than
those approved by Nokia for use with this device, to the universal
headset connector, pay special attention to volume levels.
■
Connect a USB data cable
To set the default USB connection mode, select Menu >
Settings > Data Cbl. > Data Cable Mode and the desired
mode. To set the default mode to be activated automatically,
select Ask on connection > No.
3. Call functions
To adjust the volume during a call, press the volume key.
17
Capítulos
Tabla de contenido
