Worx BladeRunner X2 WX572 Manual Original página 13

Incorrect
Correct
Lock
Unlock
Tighten Guard and Guard Arm firmly
down onto material, don't raise up
the Guard Arm when cutting.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
BladeRunner
®
— A compact, easy-to-use table-top
tool for cutting wood, metal, plastic, and ceramic
tile. Lightweight and portable for use right at the
work area. Blade is stationary while user moves
the material for easier, more precise work.
BEFORE PUTTING THE MACHINE INTO
OPERATION
1. All covers and safety devices have to
be properly fitted before the machine is
switched on.
2. It must be possible for the blade to run freely.
3. When working with wood that has been
processed before, watch out for foreign
bodies such as nails or screws etc.
4. Before you turn ON the switch, make sure
that the saw blade is correctly fitted and that
the machine's moving parts run smoothly.
5. If the cutting operation will produce a high
amount of dust, especially hazardous dust
such as ceramic tile or treated wood, connect
an effective vacuum to the vacuum port (9).
BladeRunner ® X2
ASSEMBLY AND OPERATION
Action
Guard arm installation
Blade installation
Blade changing
Stabilizer bracket
adjustment
Guard adjustment
On/off safety switch
Rip cut
Cross cut
Miter cut
Internal cut
Dust collection
Store the accessories
Carrying
MAINTENANCE
WARNING: Remove the plug from the
socket before carrying out any adjustment,
servicing or maintenance. To insure proper
operation and extend tool life, prevent dust from
accumulating under the table insert (5).
a) Be sure to use a vacuum or dust extractor
for dusty cutting operations such as
ceramic tile. (See Fig. N)
b) If dust accumulates, remove the Table Insert
by lifting the latch (e). (See Fig. O)
c) Vacuum out the dust in and around the
Blade Holder. (See Fig. P)
d) Reattach the Table Insert securely.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry
cloth. Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all
working controls free of dust. If you see some
sparks flashing in the ventilation slots, this is
normal and will not damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
Figure
See Fig. A1,A2
See Fig. B1-B3
See Fig. C
See Fig. D1,D2
See Fig. E1,E2
See Fig. F
See Fig. G1-G3
See Fig. H1,H2
See Fig. I1,I2
See Fig. J
See Fig. K
See Fig. L1,L2,L3,L4
See Fig. M
EN
13