INIM Electronics PREVIDIA MAX FPMEXT Manual De Instrucciones página 6

FPMEXT LED
Extinguishment
channel activation LED
Extinguishment channel
disabled LED
Automatic activation
Manual activation LED
Manually locked
extinguishment LED
Lock extinguishment
command LED (lock
command from non-
electrical-device)
Generic fault LED
CPU fault LED
3 Mounting FPM modules to the front plate
Refer to Figure 2 - PRCAB + FPM, page 20.
The front-plate modules (FPMCPU, FPMNUL, FPMLED, FPMLEDPRN, FPMEXT) can be mounted to one of the
apertures on the cabinet front plate.
1. Align the 6 holes on the module frame (paragraph 2 - [B]) with the 6 holes on the cabinet front-plate.
2. Secure the module in place by fastening the supplied screws into the aligned holes.
3. Connect the CAN BUS wire ([A] supplied):
- if the module is mounted in the upper aperture, the CAN BUS wire must be connected between the
module port ([B], paragraph 2 - [C]) and the CAN bar port ([C])
- if the module is mounted in the lower aperture and another module is mounted in the upper aperture, the
CAN BUS wire must be connected between module port ([D], paragraph 2 - [C]) and the appropriate port
on the upper module ([E], paragraph 2 - [D])
4. Fit the ferrite ([F], supplied) to the connected CAN BUS cable.
6
Colour
Red
Yellow
Red
LED
Red
Yellow
Yellow
Yellow
Yellow
On solid
Discharge activated
Channel disabled
Automatic discharge
command activated
Manual discharge command
activated
Extinguishment locked
Extinguishment locked
/
Generic CPU fault on
extinguishment module
Mounting FPM modules to the front plate
FPMEXT
Flashing
Pre-extinguishment condition
running
/
Automatic discharge
command partially activated
/
Fault on lock-extinguishment
circuit
Fault on lock-extinguishment
circuit
Generic fault on
extinguishment channel
/