Address Switch Setting - Panasonic CZ-64ESMC2 Instrucciones De Instalación

WA RNI NG
Gap
Gap

4. Address switch setting

To avoid an electric shock hazard,
DO NOT touch any terminal on the
Printed Circuit Board with a metal
rod, a screwdriver edge nor a bare
handwhen power is supplied.
Dip switch
How to reach the P.C. board
Remove the fl at-top screw on the bottom of the back case. When you open
up the decorative cover, you will see two notches under the control unit.
Inset a coin or other fl at object into these notches and pry off the back case.
The P.C. board on the back of the control unit is now visible.
To Installers,
After installation and adjust-
ment, be sure to turn the
BACK UP switch ON.
All bits are set off
when shipped from
factory.
PCB of the control unit
EN
9