Getting Started; Filling Water Tank; How To Use Humidifier Controls - Vornado evap3 Guía Para El Usuario

Getting Started

Filling Water Tank

This Humidifier has a 1.5 gallon capacity and 2.6 gallon output in 24
hours (if set to High Fan Speed, Continuous Humidity setting).
To fill Water Tank:
1. Unplug Humidifier. Place on firm and level surface, such as the
floor.
Note: Spills can occur during cleaning, moving, or refilling
Water Tank, so be careful to avoid spills when doing these
activities.
2. Remove Water Tank by grasping recessed handle on top (A). Pull
outward and lift (B).
3. Turn Water Tank upside down.
4.
Remove Cap (C). Empty any remaining water inside Water Tank.
Rinse, wipe clean and dry with clean cloth or paper towel.
5. Place Water Tank in sink with opening at the top.
6. Fill Water Tank with cool tap water (D).
7. Ensure Gasket is properly positioned and secure Cap.
8. Lower Water Tank into Base, positioning Fill Port over raised
bump in Base. Once in nested position, the water outlet valve
inside Cap will open, releasing water into Base.
8 English
Read and understand this owners guide before operating this product.
Position unit to not blow directly on objects or plants. Plug unit into a
110-120 volt AC outlet.
Power Button (A) - turns the unit On or Off. LED indicator lights will
illuminate default settings when powered On. Unit will default to
High Fan Speed, Continuous Humidity.
Fan Setting Button (B) - select desired Fan Setting. On the EVAP3
select - Low, High or Auto. On the EVAP1 select - Low (I), Medium (II) or
High (III).
Low or (I) - operation for quiet, nighttime use or smaller rooms. On
Low operation, your Humidifier may run without refilling for extended
periods.
Medium or (II), EVAP1 Only - operation for normal use.
High or (III) - operation for fast humidification for larger rooms. High
8 | English

How to Use Humidifier Controls

EVAP3 Pictured
speed operation will evaporate 2.6 gallons of water (+/- 10%) in 24
hours of continuous operation. (This assumes room conditions of 70º F
and 30% relative humidity.)
Auto, EVAP3 Only - operation for more precise humidity control. Fan
speed will fluctuate to better maintain set humidity level with the
minimal amount of fan noise.
Humidity Button (C) - sets desired humidity level. Press Humidity
Button until desired humidification level is illuminated, 35% - 60% or
Continuous. The unit will operate until the desired humidity level is
reached, at this point, the fan will turn Off and the fan speed indicator
light will turn Off. The humidity level indicator light will remain On. If
the fan does not turn on, the set humidity level may be lower than the
room humidity level. Increase the humidity set point until the fan turns
On. This is an indication of the level of humidity already in the room.
If moisture forms on walls or windows, lower humidity settings or turn
Off Humidifier.
English 9