Installation With Electric And Induction Cooktops - Thermador Masterpiece Serie Manual De Instalación

I N S T A L L A T I O N
Take measurements
1. Refer to the cooktop installation instructions for dimensions of
cooktop, countertop cut-out, and cabinet requirements. However,
it is recommended that oversized cabinets be used for easier
installation. Custom island designs need to account for deeper
cabinets, especially when mounting the blower behind the
downdraft. You must also plan for an access door.
Pay special attention to the areas of potential interference highlighted
below. A countertop with (A) a raised lip and/or (B) a backsplash may
not allow enough lat countertop for a proper installation. Note that a
minimum of 2-3/4" (70mm) of lat countertop is required behind cooktop
(C) and that a minimum of 2-3/4" (70mm) is necessary between the back
edge of the cooktop and the inside of cabinet back (D).
FLAT COUNTERTOP (C)
2-3/4" (70) MIN.
A
COUNTERTOP
FRONT TO BACK
INSIDE CABINET DEPTH

Installation with Electric and Induction Cooktops

Dimension "BT" is thickness of
the backsplash. Provide 1/2"
(13mm) clearance between the vent
cutout and the backsplash. Any
backsplash with a curved radius
where it meets the counter will
require additional clearance. Thicker
backsplashes may be used by
increasing the counter and cabinet
depths.
Set the cooktop into the coutertop
opening so that the back edge of the
cooktop overlaps the leading edge of
the downdraft.
TEMPLATE
2-1/8" (54) MIN.
COOKTOP
DOWNDRAFT
2-3/4" (70) MIN.
5/8" (16) MIN.
Downdraft cutout width:
30" (762) is 27-1/16" (687)
36" (914) is 33-1/16" (840)
BT
MIN.
1/2"
(13)
Cut countertop opening
1. Lay out and cut the cooktop cut-out far enough FORWARD so
downdraft will it behind it.
2. Set cooktop in place and slide it as far forward as possible without
exposing any gaps. Center and square it with edges of countertop.
C
B
3. Place the plastic template against the back lange of the cooktop.
Center the template. Trace around template to mark the
downdraft opening.
D
4. Remove cooktop from countertop.
5. Cut downdraft opening. Be careful not to chip edges of countertop.
Template
2-1/8" (54)
2-1/4" (57)
25-7/16" - 25-9/16"
22-11/16" - 22-13/16"
(576 - 579)
19-7/8" - 20"
(505 - 508)
11/16"
(17)
Cooktop cutout width
Measurements in inches (mm).
(646 - 649)
Page 13