Cleaning And Care - Klarstein Frostica Manual Del Usuario

Drain the water
• When the appliance is used for the first time or has not been used for an extended
period of time, drain any water remaining in the appliance. To do this, unscrew
the drainage screw and place a container under it to collect stale water. The first
and second ice making cycles are just for cleaning the tube system. The resulting
ice should never be consumed. After the water has been drained and the draining
screw is tightened again, the normal ice making procedures can begin and you can
use the ice.

CLEANING AND CARE

1 If the compressor stops for any reasons, such as water shortage, too much ice,
power off, etc., do not restart it right away. Wait at least 5 minutes before restarting
to protect the compressor.
2 Check the connectors of the water inlet and outlet tubes regularly and drain the little
surplus water that may occur.
3 If the ice maker will be unused for long periods of time, please screw off the plastic
drainage connector screw on the back of the ice maker so as to drain the surplus
water and place a container underneath to collect the water. Then screw it on.
Wipe the inner liner of the ice storage container with a clean rag.
4 Pull out the mains plug only at the plug head and do not pull on the cable under
any circumstances.
5 Clean the ice maker and its water supply system at least once a month. Unplug the
appliance from the wall outlet before cleaning.
EN
19