Blaupunkt Q Serie Guía Rápida página 5

2. Q-ProHub Appearance
1
1
2
2
3
3
9
9
1. Status LED (Red & Green)
Red On – Arm mode
Red Flash – Home mode
Green Flash – Learning mode
Green Off – Walk Test mode or Disarmed
2. Alarm & Fault Status LED (Red & Yellow)
Red On – Alarm in Memory
Red Flash – Alarm
Yellow On / Flash – System Fault
3. Standing Bracket (For desktop deployment)
4. USB Port: For DG2-Pro and DG4-Pro
IMPORTANT - Read before installation
• Make sure the installation sight is close to the router or a network Ethernet port.
• Do not install the Q-ProHub at open visible sight to avoid non-authorized manipulation.
• Tamper protection for the Q-ProHub is working only for wall installation. This is because the detachment of the
Q-Pro from the wall mounting bracket will activate the tamper alarm.
• The Q-ProHub tamper is pressed by the wall mounting bracket. Do not remove the wall mounting bracket even if you
decide to use the desk-stand. The Q-ProHub will not function properly without the mounting bracket attached at its back.
10
10
11
11
5. Learn / Reset Button
6. Ethernet Port
7. ON/OFF Battery Power Switch
8. Power Supply connector. DC 12V 1A
9. Panel Tamper
10. Wall Mounting Knockouts x 2
11. Bracket Hooks
12. Mounting Bracket
4
4
5
5
6
6
7
7
8
8
10
12
12
11
5