Kruger KX130 Instrucciones Para El Uso página 15

9
MAINTENANCE , REPAIRS AND STORAGE
Before undertaking any work on the appliance always detachthe plug
from the power socket
Undertake only the maintenance operations described in the user instructions.
Contact the Technical Assistance service for all other interventions.
Use only original spares.
Should the power cable be damaged, it must be replaced by a cable or a set of special cables available from
the manufacturer or its assistance service.
The pins and joints of the connection cables of the electrical system must be protected against accidental water sprays.
STORAGE
Store the appliance in premises protected against freezing conditions.
If freeze protection is not guaranteed, suction a glycol based anti-freeze into the pump, as for cars
- Immerse the water pipe into the container of anti-freeze
- Immerse the gun without the sprayer nozzle into the same container
- Insert the appliance with open gun
- Activate the gun until an even jet is obtained.
Store the rest of the anti-freeze in a closed container.
Treatment of waste from electric/electronic equipment
Dispose of the product in accordance with current regulations concerning differentiated waste disposal in de-
dicated waste disposal areas. Do not treat as simple urban waste.
For any information please contact the manufacturer at the address specified in the user manual.
The product complies with the requirements of the new directives introduced for the environmental safe-
guard and must be disposed of appropriately at the end of its life cycle.
10
TROUBLESHOOTING
Before starting any work the machine, unplug the power cable, turn off the water supply and actuate the spray
gun until the pressure has been relieved completely.
Fault
Pressure fluctuates or drops
Motor hums when switched on, but
does not start
Motor will not start when switched
on
Motor stops
The detergent fails to come out
Jet is ineffective, ragged unsteady
Cause
Lack of water
Water filter clogged
Mains voltage too low
Spray gun not actuted
Cross-section of extension lead too
small
Power supply not OK
Mains fuse tripped
Motor protection switch tripped
due to motor overheating
Clogged injector
Clean the nozzle of the foam
launch
Selector sleeve for type of jet
wrongly set
15
Remedy
Turn on water supply
Clean the water filter on the pump
supply tube.
Check electrical connection
On switching on the machine,
engage the gun
Use correctly dimensioned exten-
sion lead, see "Connect machine to
power supply"
Check plug, cable and switch
Resert mains fuse
Check that power supply matches
appliance voltage, wait 3 minutes,
then switch machine on again
Clean the detergent spray nozzle
element
Clean the high pressure nozzle.
Adjust selector sleeve