Function Fields And Values; Duplicated Codes - golmar TL4003ML Manual De Instalación

ACCESS CONTROL PROGRAMMING
Coming from previous page
7 0
*
8 0
*
9 0
0
It's possible to activate both relays simultaneously. Simply repeat one of the activation codes
for both relays.
On systems that use the power supply included on the kit to activate the connected devices
(i.e. two lock releases) simultaneously, the maximum load of this power supply must be
calculated. If necessary, an additional power supply can be used to activate these devices.
The connection of an additional TF-104 transformer, to activate a second lock release,
is shown on page 54.
It defines the installer PIN code to enter into programming
mode.
A 6 digits code must be always used. Once this code
has been introduced, 2 acoustic tones will be heard:
introduce the code again and 4 slow acoustic tones
*
will be heard to confirm the changes.
Factory default: 271828.
It defines the user PIN code to enter into programming
mode.
A 6 digits code must be always used. Once this code
has been introduced, 2 acoustic tones will be heard:
introduce the code again and 4 slow acoustic tones
*
will be heard to confirm the changes.
Factory default: 314159.
It allows to enable or disable the acoustic signal that's
reproduced when a key is pressed. This function
hasn't effect during programming mode.
Select 0 to disable this function.
Select 1 to enable this function.
1
or
Factory default: 1 (enabled).
F
unction fields and values.
D
uplicated codes.
50