Enter And Exit From Programming; Programming Structure And Sequence - golmar TL4003ML Manual De Instalación

ACCESS CONTROL PROGRAMMING
2 7
To program the access control functions, it will be necessary to enter the function field
followed by the corresponding value. Sometimes, this value will be predefined
(i.e. relay 1 contact type) and sometimes will be selected by the installer.
Once into programming mode, the programming sequence is as follows:
1 1
1 8
If a wrong value has been introduced, press cancel key (C). The keypad will reproduce 1 large
acoustic tone. If cancel key has been pressed during the introduction of the function field,
even after the confirming tones, the function field must be entered again; if cancel key
has been pressed during the introduction of the function value, introduce a new value.
3
C
To enter into the programming menu, press key symbol and enter
the installer PIN code (factory default: 271828)
or the user PIN code (factory default: 314159).
To exit from the programming menu press key symbol at any moment.
On both cases, the module will reproduce 5 fast acoustic tones.
1 8 2
Enter the function field to be programmed: this is a
Enter the value of the function under programming.
2 8
Enter the next function field to be programmed or
C
2
1
8 or 3 1
2 digits code. The module will reproduce a 2 slow
acoustic tones.
Once the value has been entered, the module
will reproduce a 4 slow acoustic tones.
press key symbol to exit from the programming mode.
1 5
C C
E
nter and exit from
programming.
4 1 5 9
P
rogramming structure
and sequence.
4
9 9
C
46