Phasak ON-LINE 1000VA Manual Del Usario página 57

Software
Power Management
Software
Physical
Dimensions
Net Weight
*) Within 50/60Hz±8% by default, the output frequency is synchronization with input mains. User can adjust the
acceptable range for output frequency (±1, 2, 3, 4, 5, 6, 7, 8, 9, 10%). When input frequency is out of synchronization
window but within 40-70Hz, UPS can stay in line mode and output frequency is regulated at 50/60Hz+0.5% with load
derating by 40%
Problem
Warning
Your equipment requires more power than the
UPS can provide. If the UPS is in Line Mode
O/P Overload
then it will transfer to Bypass Mode; if the UPS
is in Battery Mode it will shutdown.
Battery Mode UPS is operating on battery power.
UPS is operating on battery power and will be
Battery Low shutting down soon due to extremely low battery
voltage.
Missing battery power.
BAT Disconnected/
Battery Replace
UPS has failed in Battery Test.
Charger Failure Charger has failed.
EPO OFF Missing the EPO connection.
Fault
Over Temperature High ambient temperature.
Output Short Output short circuit.
High O/P V Output voltage is too high.
Low O/P V Output voltage is too low.
Bus Fault Internal DC bus voltage is too high or too low.
Other
D×W×H = 15.37 x
5.51x7.50x12.76in.
(140x190.6x324mm)
(390×151×225 mm)
(10.1/7.7Kg)
Possible Cause
ON-LINE 1000VA / 2000VA / 3000VA
​
P H 9210 - PH 9220 - PH 9230 .
Power Master
D×W×H = 16.23 x 7.72 x
5.95 x 8.86in. (412×196×342 mm)/
D×W×H = 15.37 x 5.95 x 8.86in.
(390×151×225 mm)
(15.3/7.8Kg)
Solution
Shut off non-essential equipment. If this solves
the overload problem, the UPS will transfer to
normal operation.
Save your data and perform a controlled-
shutdown.
UPS will restart automatically when acceptable
utility power returns.
Check battery connector when use battery
packages.
Contact technical support to replace the battery.
1. Shut down UPS and turn off AC input.
2. Contact ​ y our dealer​ for repair.
Check the EPO connection.
1. Shut down UPS. Restart UPS to Check the
fan for operation and if the ventilation hole has
been covered
2. Contact your dealer for repair.
1. Shut down UPS
2. Your attached
problems, please remove them and check
again.
1. Shut down UPS
2. Contact your dealer for repair.
13.47in.
(23.8/8.0Kg)
equipment may have
56 / 58