Dust Cup Cleaning - Kenmore 116.39050 Manual De Uso Y Cuidado

DUST CUP CLEANING
TO DISASSEMBLE DUST CUP TO ASSEMBLE DUST CUP
Remove dust cup from vacuum cleaner (See DUST CUP EMPTYING) and empty
contents
1. Rotate upper dust
cup to unlock, then lift
off,
2. Remove pre-filter by
pulling downward as shown,
See PRE-FILTER
CLEANING
3. Press the lid
release button
downward and
twist lid to remove
from dust cup,,
4. Rotate fastener ring
to unlock, and lift off,,
5o Remove upper
portion of dust cup
from air guide,,
6. Rinse with cold water
only, DO NOT use
detergent or soap, Allow
parts to dry 24 hours
before putting back into
vacuum cleaner,
DO NOT wash in the dishwasher.
DO NOT install parts damp.
18
1, Reinstall upper portion
of dust cup onto air
guide so that the
locking screws
pass through
the holes in the
upper portion,
3. Place the dust cup
lid on the upper portion
of the dust cup using
aligniment slots, and
rotate until the lid locks
in place.
2. Using alignment marks
on the fastener ring and
dust cup, place fastener
ring onto dust cup and
rotate to lock in place
4. Reinstall pre-filter
by using the
alignment ribs on the
pro-filter to align with
the ribs on the upper
portion of the dust
cup
5, Press into place A noticeable "click"
should be heard,
6. Reinstall lower I_
portion of the dust cup _
by aligning ribs on the
upper portion with the
UNLOCK ribs on the I v
lower portion,
L_
7. Rotate until ribs from the upper portion
of the dust cup align with the LOCK ribs.
NOTE: If lower portion of dust cup does
not fit properly check pre-filter installation
in step 4,