Kenmore 116.39050 Manual De Uso Y Cuidado página 24

Reviewthistabletofind do-it-yourself solutionsfor minorperformance problems, Any service
needed, o therthanmaintenance d escribedin this Use& CareGuide,shouldbe performed by
a Searsor otherqualifiedserviceagent.,
WARNBNG
Disconnect electrical supply before performing maintenance to the vacuum cleaner.
Failure to do so could result in electrical shock or personal injury.
Vacuum cleaner
won't run.
Poor job of dirt
pick.up.
Vacuum cleaner picks
up moveable rugs or
pushes too hard.
Agitator does not
turn.
Airflow restricted
with attachment use;
sound changes.
OSSt
1. Unplugged at wall outlet.
2.. Tripped circuit breakerlbtown fuse
at household service panel-
3. Thermal protector tripped.
4. Defective wall outlet,,
I, Full or clogged dust cup.
2, Wrong pile height setting.
3, Worn agitator
4, Clogged nozzle.
& Clogged hose.
6, Hole in hose.
7, Hose not inserted fully.
8o Motor protection system
activated.
9. Dirty filter(s).
t0. Dust cup not assembled
correctly
1. Wrong pile height setting.
I. Handle in full upright position,
2, Agitator overload tripped,
3, Thermal protector tripped,
t, Attachment use restricts air flow.
2, New carpet fuzz clogged air path
1. Plug in firmly, select the
desired setting on the touch
control_
2. Reset circuit breaker or replace
fuse
3. Allow vacuum cleaner to cool
40-50 minutes,
4. Check with a good appliance or
lamp Have outlet properly
serviced.
1. Empty dust cup
2. Adjust setting.
3, Replace agitator,
4. Check CLOG REMOVAL.
5. Check for clogs
6. Replace hose
7. Insert hose fully
8. Check for clogs.
9, Ctean or change primary filter
and/or change exhaust filter.
10, Remove dust cup and reinstall.
I. Adjust setting,
1. Move handle from upright
position.
2o Reset agitator overload protector
3, Allow vacuum cleaner to cool
40-50 minutes.
I_ Check ATTACHMENTS for fuzz,
lint, pet hair or olher debris.
2. Check CLOG REMOVAL and
clean hose.
24