Tabla de contenido
Idiomas disponibles
Idiomas disponibles
opEration
Basic DeVilbiss SleepCube Controls
Name
Symbol Function
DELAY
NOTe– The additional control buttons that you see on the SleepCube control panel provide
advanced controls for specific settings. Please refer to the 'Advanced Menu Controls'
section on page 13 for more details.
oPeRaTion
Startup
To begin operation, verify that your SleepCube is connected to a
'live' power source. When plugged in, the LCD display should
appear as noted.
Put on your CPAP mask and press the ON/OFF button on the keypad to turn on airflow OR
put on your CPAP mask and take a few breaths to turn on airflow automatically. The
pressure in your mask will rise to the set pressure in about 10 seconds.
NOTe– If the device does not automatically start after taking 2-3 breaths, this feature may have
been disabled. If Auto ON/OFF is disabled, you must manually press the ON/OFF
button to start and stop the device.
The keypad display shows the actual mask pressure while the
device is in use. Because this is the actual pressure, the device
pressure reading may vary slightly as you breathe. Your display
should appear as noted.
If your DeVilbiss SleepCube system includes a humidifier, its
heater controls and status are displayed as noted in the image.
NOTe– If the display on your device is not similar to those listed
above, refer to the chapter section titled "Patient Messages" on page 17.
Using The Comfort Delay Feature
Your SleepCube has a comfort delay feature to help make it easier for you to fall asleep. The
airflow will start at a low pressure and then gradually ramp-up to the prescribed setting over
the last few minutes of the specified delay time.
The Delay button activates the comfort delay feature and only
functions if this feature has been enabled. To understand how to
set the parameters of this feature, please refer to the Using the
Comfort Delay Feature found on page 11.
EN
OFF
P:10.0
ST
P:10.0
ST
Heat:Off
SE-DV56
11
Capítulos
Tabla de contenido
Solución de problemas
