Master MH-221A-120 Manual Del Usaurio página 4

Operation
1. Position the fan heater so that it stands upright on a
firm, level surface, and at a safe distance from wet
environments and flammable objects.
2. Set the Thermostat Control Dial to the highest
setting. This is to the right on the 221A-120 and to
the left on the 222A-120. On the 221A-120, turn
knob all the way to the right to achieve the highest
setting. It is past the printed markings.
3. Connect the fan heater to the proper electrical power.
4. The fan heater will switch on when the Function
Control Dial is set to one of the four power settings.
Setting
Unit is Off
Fan Runs - No heating
Fan Runs - Low Heat
Fan Runs - High Heat
5. When using the heater for the first time, you may
notice a slight emission of smoke. This is normal
and will stop after a short time. The heating element
was coated with a layer of protective oil during
production. The smoke is caused by the leftover oil
as it is heated.
© 2019 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
Operation
Function
Automatic Overheat Safety Control
– This heater is equipped with safety internal heat
limiting thermostat and overheat protection circuit.
When a potential overheat temperature is reached,
the system will automatically shut off the heater.
Thermostat Instructions
– Set the Thermostat Control to the highest setting and
let the heater operate with full power input. When
the room temperature reaches the required value,
turn the thermostat down until it switches off.
– The thermostat will then switch on and off
automatically to control the room temperature
according to the preset value and keep the room
temperature constant.
3
Electric Fan Heater User's Manual