Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TILTING
This fixture allows for up to 45° tilt. Due to physical
limitations of varying ceiling thicknesses, trim aperture, and
number of additional lens media, full 45° rotation and/or full
light output may not be possible.
There are tilt angle markings on the inside of the
mechanism.
For round and square wall wash trims, the optimal tilt angle
is 15° (Figure 13).
1.
Insert Phillips screwdriver into tilting bracket (Figure
11). Unlock mechanism by turning the locking screw
counterclockwise a few turns will loosen the brake. Tilt
the mechanism to the desired tilting angle.
2.
Turn locking screw clockwise to lock fixture tilt.
Figure 11
TRIM INSTALLATION
1.
To clean, gently wipe with a soft, clean, dry lint-free
cloth to remove dust.
2.
In the event fingerprints are placed on the reflective
area, use a mild detergent solution on a soft clean cloth
to remove them. Wipe with clean water and dry with a
soft, clean, dry lint-free cloth.
3.
The above cleaning method can be used anytime during
the life of the trim.
4.
Remove overspray protector.
5.
Attach trim tether clip to aiming bracket (Figure 12).
6.
Align mounting plates with magnets and place trim
against ceiling (Figure 12).
7 .
If using a wall wash trim, the angle of the trim lens
should align with the direction and angle of the
mechanism head (Figure 13).
Installation Instructions – HL36A and HL36SA Recessed Adjustable LED
Figure 12a
Figure 12b
Figure 13
Aiming bracket
Tether Clip
Magnets - 4 Sets
Magnet Plates 4X
Wall
Wall Wash
15° Tilt
Wall Wash Trim
Orientation
5
Tabla de contenido
