Control Panel; Directions For Use - Gima H100 Instrucciones Para El Uso

CONTROL PANEL:

1. MASTER SWITCH
2. STARTING KNOB
3. "START" LIGHT
4. "HEATING" LIGHT
5. "STERILIZING" LIGHT :
6. "ALARM" LIGHT
7. STERILIZING
COMPLETE" LED
Autoclave GIMA H100 automatic
10

DIRECTIONS FOR USE

(see picture no. 8)
: (green lighted)
switch on/off to turn on/off the autoclave.
Symbols printed :
- "0" =
- "I" =
: To start the cycle of sterilization turn it clockwise following
the increasing symbols printed on the panel till the end (15
minutes)
: (green)
it shows the beginning of sterilization cycle
: (green)
it shows when electric
that it heats water.
(green)
it shows that the
temperature and that it is in sterilizing phase
minutes).
: (red)
it shows that
and safety thermostat has worked (for the new working of the
autoclave you must push the red button of safety thermostat).
See chapter 11, on page 75).
: (green lighted)
and shows that sterilization cycle has finished (the knob of
the timer has automatically come back to "0".
- 61 -
OFF
ON
resistance is working, which means
autoclave has achieved
temperature achieved 135 °C temperature
125°C
(lasting 15